Motion Metrics International | Brass Nut

Beretta hit the ropes, but Jado nailed him with a kendo stick from the floor, as the Guerillas took over. Jado continued to attack Beretta with the stick on the floor. Loa hit Beretta with an attitude adjustment on the apron. 

– Apply a light coat of grease to the bearing race, as this is what the bearing slides on inside. Repeat the process on the bottom race.

Here, we’re looking at how to set up a variety of Gibson-themed instruments, as well as their copies.

Neps Thermal long-sleeve crew by Sol Angeles, $128, and Tyler slim-fit jean in Asphalt Seriously Soft by J Brand, $198, both at Beecroft & Bull.

With your action set and test played for buzzing, it’s time to set the intonation. Your new strings may have a different intonation setting required – never just assume! Play a harmonic at the 12th fret and then compare it to the fretted note at the same fret. If it’s sharp, move the saddle backwards. If it’s flat, move it forwards.

Available with two hydraulic options, the company says the Battle Ax has a fixed-displacement gear motor that operates at a constant RPM, which Loftness says provides an optimal balance between speed and torque. The company says customers can also choose a variable-displacement piston motor, which automatically shifts the rotor RPM from the highest speed to a lower range for increased torque, as needed.

Thompson was concerned about durability since the mountainous terrain is often scattered with rocks partially disguised by leaves and brush. The Shark Tooth, made in the United States with AR 400 steel, is holding up well so far but he’s prepared to sharpen it if needed.

“The main goal for rental companies is to have high utilization rates of their equipment because if its sitting on the lot, then it’s not making money for the business. Adding machines to a fleet that only can do certain tasks can be costly and inefficient for rental stores. Adding a variety of attachments to a rental fleet increases the utilization rate of the tool carriers themselves and is also much more cost effective,” Boerger says.

At this point in the tournament, the Guerillas of Destiny are in the lead, commanding eighteen points in first place. EVIL & SANADA, Tomohiro Ishii & Toru Yano and the Killer Elite Squad are not too far behind with sixteen points. It’s still anyone’s game.

Solesbee’s says the attachment’s two shanks easily cut through roots to allow operators to remove stumps without displacing large amounts of dirt. The shank’s curved design significantly increases breakout force, the company says, for slicing through tough surfaces when extracting forestry material.

Yano untied a corner pad. Umino missed a charge into the corner, and ran into the exposed buckle. Umino hit a missile dropkick, then tagged Yoshida. Yoshida landed a PK for a nearfall. Umino hit a second missile dropkick after a tag. 

“The teeth have to cut through the material causing the least amount of drag on the bucket,” says Horton. “The fewer the teeth engaged with the substrate, the more penetration. However, the teeth will wear faster and have to be replaced more often. A sharp single spike tooth will have high penetration but a shorter life. Twin tigers offer high penetration but also side ripping when used on the corner bucket locations.”